Website powered by
Damien Ramirez (CG)
3D Generalist - Advisor
Home
Resume
Store

Brushify - Adding Height Control to Foliage

A WPO trick by Karyna Trychyk. The correct way to add it is here: https://x.com/karynatrychyk/status/1617222481873453058 This is just a quick Dev hack to get it working in Brushify if you need longer/shorter grass for your project.

Find your Grass/Foliage master material & duplicate it.

Find your Grass/Foliage master material & duplicate it.

If you don't copy the Material & duplicate it you will find small issues with other foliage as they all share the master material.

If you don't copy the Material & duplicate it you will find small issues with other foliage as they all share the master material.

Add the code in the redbox to WPO, I found subtracting it from the material setup already there works best (there is another way but this is quick & easy). The Red Line goes into the Albedo Textures RGB ouput.

Add the code in the redbox to WPO, I found subtracting it from the material setup already there works best (there is another way but this is quick & easy). The Red Line goes into the Albedo Textures RGB ouput.

Open the foliage Material Instance

Open the foliage Material Instance

Change the Parent material in the foliage mesh material instance to the duplicated material you just edited.

Change the Parent material in the foliage mesh material instance to the duplicated material you just edited.

Just adjust settings for different results.
-Not always perfect results but with adjustments it works.

Report